고온초전도 선재와 정합회로를 이용한 RF coil 제작에 대한 기초연구
Study on fabricated RF coil using high-temperature superconductor tape and matching circuit for low field MRI system
※ 기관로그인 시 무료 이용이 가능합니다.
※ 학술발표대회집, 워크숍 자료집 중 4페이지 이내 논문은 '요약'만 제공되는 경우가 있으니, 구매 전에 간행물명, 페이지 수 확인 부탁 드립니다.
4,000원
원문정보
초록
영어
The substantial improvement of the signal-to-noise ratio (SNR) can be achieved with small-size samples or low-field MRI system by high-temperature superconducting(HTS) RF coil. The typical HTS RF coil made of HTS thin film is expensive and is limited the coil geometry to planar surface coil. In this study, commercial Bi-2223 HTS tapes was used as RF coil for a 0.35T permanent MRI system. It has advantages of both much lower cost and easier fabrication over HTS thin film coil. SNR gain of the image obtained from the HTS RF coil over a conventional Cu RF coil at room temperature was about 2.4-fold and 1.9-fold using the spin echo pulse sequence and gradient echo pulse sequence respectively.
목차
Abstract 1. 서론 2. 실험 방법 2.1. 표면 코일 제작 및 특성 평가 2.2. MRI system 및 image parameter 2.3. 영상 재구성 및 SNR 측정 3. 실험결과 및 고찰 4. 결론 참고문헌