Earticle

초록

영어

The OADM based on DWDM technology is moving the telecommunications industry significantly closer to the development of optical networks. The OADM can be placed between two end terminals along any route and be substituted for an optical amplifier. Commercially available OADMs allow carriers to drop and/or add up to multi channels between DWDM terminals. By deploying an OADM instead of an optical amplifier, service providers can gain flexibility to distribute revenue–generating traffic and reduce costs associated with deploying end terminals at low traffic areas along a route. The OADM is especially well-suited for meshed or branched network configurations, as well as for ring architectures used to enhance survivability. Moreover, An optical add/drop multiplexer with tunable bandwidth offers several potential advantages, including optical performance monitoring and dynamic bandwidth allocation. This paper has proposed OADM for high transmission bit rates and products in next generation optical communication networks based on dense wavelength division multiplexing for different fiber link lengths at room temperature for best performance efficiency.

목차

Abstract
 1. Introduction
 2. Optical Add-Drop Multiplexing
 3. Modeling Analysis
 4. Simulation Results and Performance Evaluation
 5. Conclusions
 References

키워드

저자

• Ahmed Nabih Zaki Rashed [ Electronics and Electrical Communication Engineering Department Faculty of Electronic Engineering, Menouf 32951, Menoufia University, EGYPT ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Multimedia and Ubiquitous Engineering

• 간기

  월간

• pISSN

  1975-0080

• 수록기간

  2008~2016

• 등재여부

  SCOPUS

• 십진분류

  KDC 505 DDC 605