Earticle

초록

영어

A cutting fluid can improve machining quality and tool life by maintaining the tool toughness and by providing a lubrication effect to reduce the friction between the chip and tool interface. Although liquid nitrogen as an environmentally safe coolant has been widely recognized in cryogenic machining, its function as a lubricant is plausible due to its chemical inertness, physical volatility and low viscosity. Since a reduced friction is a direct witness of the lubrication effect from a tribological viewpoint, this paper presents an evaluation of the apparent friction coefficient on the tool-chip interface in cryogenic cutting operations to prove and characterize the lubricity of LN2 in cryogenic machining. The mathematical approaches have been formulated to derive the normal and frictional forces on the tool-chip interface for the oblique cutting tests.

목차

Abstract
 1. Introduction
 2. Evaluating the Normal and Frictional Forces
 3. Experimental Setup
 4. Experiment Result and Discussion
 5. Conclusion
 6. References

저자

• 전성찬 [ Jun Seong Chan | Columbia Univ. ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  대한안전경영과학회지 [Journal of Korea Safety Management & Science]

• 간기

  계간

• pISSN

  1229-6783

• eISSN

  2288-1484

• 수록기간

  1999~2025

• 십진분류

  KDC 530 DDC 620