T.K. Ghosh, Shounak Banerjee, C.B. Majumder, Tai-hoon Kim
언어
영어(ENG)
URL
https://www.earticle.net/Article/A147517
※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.
원문정보
초록
영어
Air supply is a crucial parameter for many aerobic processes. Specific growth rate (μ) was determined for both the reactors (conventional UT-ALF and modified CDT-ALF) under identical operating conditions. The conventional uniform tube external loop airlift fermenter (UT-ALF) was modified keeping the volume and height same. Only the riser part of the conventional external loop airlift fermenter was replaced by a irregular geometry in the form of converging-diverging tube. The modified system is thus named converging-diverging tube airlift fermenter (CDT-ALF), which possesses a novel geometry comprised of walls with sinusoidal waves that mimic baffles in an effort to promote mixing at low Reynold’s number (Re). This geometry provides a unique hydrodynamic environment suitable also for the cultivation of mammalian cells and tissues. The results from UT-ALF and CDT-ALF were compared. At any operating condition CDTALF showed higher μmax (maximum specific growth rate) compared to UT-ALF. The highest (μmax) was observed for CDT-ALF corresponding to an initial sugar concentration of 50 kg/m3 and air flow rate of 1.0 vvm. This was 29 % higher compared to UT-ALF under identical operating conditions. So, operating cost may be minimized to a great extent if commercialized.
목차
Abstract 1. Introduction 2. Experimental 3. Materials and methods 4. Results and Discussion 4.1 Dependence of specific growth rate ( μ) on air flow rate and initial glucoseconcentration of 10 kg/m3 and 30 kg/m3 4.2 Effect of air flow rate on specific growth rate (μ) when initial glucoseconcentration was increased to 50 kg/m3 5. Discussion 5.1 Effect of air flow rate on μ max at sugar conc. 50 kg/m3 and above. 6. Conclusion 7. Acknowledgement 8. References
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation vol.3 no.3