Earticle

초록

영어

In this study, 91 samples were collected by layer, direction, and point from the smelting experiment furnace wall, and XRD analysis was performed. These data were compared with the geothermometer method and the cluster analysis method to determine how to effectively interpret heated characteristics. As a result of comparing the heated characteristics of the 1st to 4th floors, its showed the same results for both methods because of heated by high temperatures in the 1st and 2nd floors heated. However, in the data from the 3rd and 4th floors, it was difficult to interpret the difference in heat temperature depending on the direction using the geothermometer method, but the cluster analysis method was able to effectively confirm the pattern of heat spreading from the center to the outside of the furnace wall. As a result, the cluster analysis method can reduce errors that may appear due to mineral identification in the process of estimating heat temperature using the geothermometer method and there is an advantage in that the temperature distribution within the furnace wall can be further refined.

목차

ABSTRACT
1. INTRODUCTION
2. SAMPLES
3. METHODS
4. RESULTS
4.1. Heated temperature of smelting furnace wall samples using geothermometer method
4.2. Heated temperature according to the layers of the smelting experiment furnace wall using cluster analysis
4.3. Heated temperature according to the directions of the smelting experiment furnace wall using cluster analysis
5. DISCUSSION AND CONCLUSION
ACKNOWLEDGMENT
REFERENCES

저자

• Jae hwan Kim [ Natural Heritage Center, National Research Institute of Cultural Heritage, Daejeon 35204, Korea ]
• Min Su Han [ Department of Heritage Conservation and Restoration, Korea National University of Cultural Heritage ] Corresponding Author

참고문헌